Find Complete and recently updated Correct Question and answers of CISCO. All Answers updated regularly with new questions. Upwork CISCO test answers of 2016.

Question:* When you log into a switch, which prompt indicates that you are in privileged mode?

Answer: • #

Question:* How many maximum VLAN's can be created?

Answer: • 4094

Question:* The RSTP provides which new port role?

Answer: • Discarding

Question:* Which of the following is a valid host IP in this network: 172.27.0.0/23

Answer: • 172.27.0.255

Question:* Which of the following settings could prevent two potential EIGRP neighbors from becoming neighbors?

Answer: • IP addresses of 10.1.1.1/24 and 10.2.2.2/24, respectively.

Question:* What administrative distance would a router assign to a default route in EIGRP that is learned from a source external to the autonomous system?

Answer: • 170

Question:* What does the IEEE 802.2 standard represent in Ethernet technologies?

Answer: • Logical Link

Question:* Routers R1 and R2, currently EIGRP neighbors over their Fa0/0 interfaces (respectively), both use EIGRP authentication. Tuesday at 8 p.m. the neighborship fails. Which of the following would NOT be useful when investigating whether authentication had anything to do with the failure?

Answer: • Show ip eigrp neighbor failure

Question:* Choose the Ethernet connector:

Answer: • RJ-45

Question:* Which of the following methods is for compatibility of IPV4 and IPV6?

Answer: • Dual Stacking

Question:* Out of 256 how many can be hosts?

Answer: • 254

Question:* How many bits have IPv4 address?

Answer: • 32

Question:* Which WLAN IEEE specification allows up to 54Mbps at 2.4GHz?

Answer: • G

Question:* Usually what IP do you use to connect to a home to ISP gateway device?

Answer: • 192.168.1.1

Question:* A PC to PC connection uses ___ cable.

Answer: • crossover

Question:* Where is a hub specified in the OSI model?

Answer: • Physical layer

Question:* type of authentication Eigrp support.

Answer: • md5

Question:* Splitting a network into other smaller and smaller networks is called?

Answer: • Subnetting

Question:* A switch is a ___ device.

Answer: • L2

Question:* Which protocol does Ping use?

Answer: • ICMP

Question:* Which layer defines the physical topology?

Answer: • Physical

Question:* Which protocol should be used to establish a secure terminal connection to a remote network?

Answer: • SSH

Question:* A network admin wants to know every hop the packets take when he accesses cisco.com. Which command is the most appropriate to use?

Answer: • Traceroute cisco.com

Question:* At which OSI layer does a hub operate at?

Answer: • Layer 1

Question:* How long is an IPv6 address?

Answer: • 128

Question:* ADSL uses ____ .

Answer: • land-line telephony architecture

Question:* Which key combination is used to close a window in windows 7

Answer: • Alt+F4

Question:* A L3 switch is ___

Answer: • a switch with some routing logic.

Question:* Which one of the following is true regarding VLANs?

Answer: • VTP is used to send VLAN information to switches in a configured VTP domain

Question:* Which class of IP address has the most host addresses available by default?

Answer: • A

Question:* Which of the following commands will allow you to set your Telnet password on a Cisco router?

Answer: • line vty

Question:* Which router command allows you to view the entire contents of all access lists?

Answer: • show access-lists

Question:* Which statement describes EIGRP?

Answer: • EIGRP sends triggered updates whenever there is a change in topology that influences the routing information.

Question:* Router-on-a-stick requires what kind of port be set up on the switch port attached to the router?

Answer: • Trunk

Question:* A router is a ___ device.

Answer: • L3

Question:* How many collision domains are created when you segment a network with a 12-port switch?

Answer: • 12

Question:* What flavor of Network Address Translation can be used to have one IP address allow many users to connect to the global Internet?

Answer: • PAT

Question:* Which routing protocol is needed in a network which focuses on bandwidth and uses Cisco and Non-Cisco devices?

Answer: • OSPF

Question:* How often are BPDUs sent from a layer 2 device?

Answer: • Every 2 seconds

Question:* The CSMA/CD Ethernet IEEE is:

Answer: • 802.3

Question:* In which CLI mode does an administrator have to be in for configuring devices?

Answer: • Global Config mode

Question:* What is the first CLI mode you get in when startup the Router/Switch?

Answer: • User - mode

Question:* The administrative distance of (internal) EIGRP is:

Answer: • 90

Question:* A receiving host computes the checksum on a frame and determines that the frame is damaged. The frame is then discarded. At which OSI layer did this happen?

Answer: • Data Link

Question:* Which term defines a collection of networks under the administrative control of a single entity that presents a common routing policy to the Internet?

Answer: • autonomous system

Question:* Which of the following is NOT a Cisco proprietary protocol?

Answer: • BGP

Question:* Which is the default register in the router?

Answer: • 0x2102

Question:* Which of these protocols is NOT "distance-vector" IGP ?

Answer: • OSPF

Question:* What does a VLAN do?

Answer: • Breaks up broadcast domains in a layer 2 switch internetwork

Question:* What is a stub network?

Answer: • A network that has only one entry and exit point

Question:* Which command will create a subinterface on serial 0 (zero)?

Answer: • Router(config)# interface s0.2400 point-to-point

Question:* How many broadcast domains are created when you segment a network with a 12-port switch?

Answer: • 1

Question:* What does the 'passive' command provide to the RIP dynamic routing protocol?

Answer: • Stops an interface from sending periodic dynamic updates but not from receiving updates

Question:* If you wanted to delete the configuration stored in NVRAM, what would you type?

Answer: • erase startup

Question:* On a router running EIGRP, what database would maintain a list of feasible successors?

Answer: • topology table

Question:* On a router running EIGRP, what database would maintain a list of feasible successors?

Answer: • topology table

Question:* what is the protocol number of ospf

Answer: • 89

Question:* Which command reveals the last method used to powercycle a router?

Answer: • Show version

Question:* Choose the correct syntax to configure an IPX subinterface on a router:

Answer: • config t, int e0.100, ipx network 10, encap arpa

Question:* Which protocols are class full ?

Answer: • RIP V1 and EIGRP

Question:* Select the highest VRRP priority.

Answer: • 105

Question:* When does a loopback interface becomes up/up on a layer3 switch?

Answer: • As soon as you create it

Question:* What is a NIC?

Answer: • A card that plugs into the computer's parallel port and provides a serial connection to the network

Question:* Which of the following is the valid host range for the subnet on which the IP address 192.168.168.188 255.255.255.192 resides?

Answer: • 192.168.168.129–190

Question:* What type of port configuration should you use for PVLAN interfaces that connect to a router?

Answer: • Promiscuous

Question:* What PPP protocol provides for dynamic addressing, authentication, and multilink?

Answer: • LCP

Question:* What Protocol Does PPP use to identify the Network layer protocol?

Answer: • NCP

Question:* A vlan interface is up/down on a catalyst layer 3 switch. How can you fix this issue?

Answer: • Create the corresponding vlan and permit it on an up/up physical interface that doesn't have autostate exclude configured

Question:* Which of the following are Session Layer standards?

Answer: • NFS and SQL

Question:* A static route that points to the next hop IP will have what administrative distance and metric in the routing table?

Answer: • administrative distance of 1 and metric of 0

Question:* How many bits long is each field in an IPv6 address?

Answer: • 16

Question:* What address can be used to summarize networks 172.16.1.0/24, 172.16.2.0/24, 172.16.3.0/24, and 172.16.4.0/24?

Answer: • 172.16.0.0/21

Question:* What is the default size of the history?

Answer: • 20

Question:* What does a router running RIP do first with a new route that is received from an advertisement?

Answer: • Adjusts the metric for the new route to show the added distance for the route.

Question:* A network administrator sets up PC1 with an IP address of 192.168.1.130/27 and PC2 with 192.168.1.159/27. PC1 can't ping PC2. What's the problem?

Answer: • PC2 is a broadcast address

Question:* Which key combination is used to close a window in windows 7

Question:* What command will display the line, protocol, DLCI, and LMI information of an interface?

Wednesday, December 16, 2015

CISCO test answers of 2016.

Question:* When you log into a switch, which prompt indicates that you are in privileged mode?

Answer: • #

Question:* How many maximum VLAN's can be created?

Answer: • 4094

Question:* The RSTP provides which new port role?

Answer: • Discarding

Question:* Which of the following is a valid host IP in this network: 172.27.0.0/23

Answer: • 172.27.0.255

Question:* Which of the following settings could prevent two potential EIGRP neighbors from becoming neighbors?

Answer: • IP addresses of 10.1.1.1/24 and 10.2.2.2/24, respectively.

Question:* What administrative distance would a router assign to a default route in EIGRP that is learned from a source external to the autonomous system?

Answer: • 170

Question:* What does the IEEE 802.2 standard represent in Ethernet technologies?

Answer: • Logical Link

Question:* Routers R1 and R2, currently EIGRP neighbors over their Fa0/0 interfaces (respectively), both use EIGRP authentication. Tuesday at 8 p.m. the neighborship fails. Which of the following would NOT be useful when investigating whether authentication had anything to do with the failure?

Answer: • Show ip eigrp neighbor failure

Question:* Choose the Ethernet connector:

Answer: • RJ-45

Question:* Which of the following methods is for compatibility of IPV4 and IPV6?

Answer: • Dual Stacking

Question:* Out of 256 how many can be hosts?

Answer: • 254

Question:* How many bits have IPv4 address?

Answer: • 32

Question:* Which WLAN IEEE specification allows up to 54Mbps at 2.4GHz?

Answer: • G

Question:* Usually what IP do you use to connect to a home to ISP gateway device?

Answer: • 192.168.1.1

Question:* A PC to PC connection uses ___ cable.

Answer: • crossover

Question:* Where is a hub specified in the OSI model?

Answer: • Physical layer

Question:* type of authentication Eigrp support.

Answer: • md5

Question:* Splitting a network into other smaller and smaller networks is called?

Answer: • Subnetting

Question:* A switch is a ___ device.

Answer: • L2

Question:* Which protocol does Ping use?

Answer: • ICMP

Question:* Which layer defines the physical topology?

Answer: • Physical

Question:* Which protocol should be used to establish a secure terminal connection to a remote network?

Answer: • SSH

Question:* A network admin wants to know every hop the packets take when he accesses cisco.com. Which command is the most appropriate to use?

Answer: • Traceroute cisco.com

Question:* At which OSI layer does a hub operate at?

Answer: • Layer 1

Question:* How long is an IPv6 address?

Answer: • 128

Question:* ADSL uses ____ .

Answer: • land-line telephony architecture

Question:* Which key combination is used to close a window in windows 7

Answer: • Alt+F4

Question:* A L3 switch is ___

Answer: • a switch with some routing logic.

Question:* Which one of the following is true regarding VLANs?

Answer: • VTP is used to send VLAN information to switches in a configured VTP domain

Question:* Which class of IP address has the most host addresses available by default?

Answer: • A

Question:* Which of the following commands will allow you to set your Telnet password on a Cisco router?

Answer: • line vty

Question:* Which router command allows you to view the entire contents of all access lists?

Answer: • show access-lists

Question:* Which statement describes EIGRP?

Answer: • EIGRP sends triggered updates whenever there is a change in topology that influences the routing information.

Question:* Router-on-a-stick requires what kind of port be set up on the switch port attached to the router?

Answer: • Trunk

Question:* A router is a ___ device.

Answer: • L3

Question:* How many collision domains are created when you segment a network with a 12-port switch?

Answer: • 12

Question:* What flavor of Network Address Translation can be used to have one IP address allow many users to connect to the global Internet?

Answer: • PAT

Question:* Which routing protocol is needed in a network which focuses on bandwidth and uses Cisco and Non-Cisco devices?

Answer: • OSPF

Question:* How often are BPDUs sent from a layer 2 device?

Answer: • Every 2 seconds